| Step : 1 | Feature List as per requirement. |
| | Submit the feature list based on discussion. |
| Step : 2 | Product Selection with required features. |
| | Component selection based on cost and required by product. |
| Step : 3 | Lay out of PCB and Prototype Board |
| | As per design of enclosure / product PCB lay out with gerber out-put and films. |
| Step : 4 | Bill Of Material with costing |
| | Total BOM cost will be submitted for said products. |
| Step : 5 | Software if Micro-Controller based product (Optional) |
| | We can provide Software support also if required and we will give bug free product. Also we will support as per agreement. |
| Step : 6 | Prototype Board |
| | Once design will complete we provide proto board to feel the product out-put.
If any changes is required we redesign and submit to customer. |
| Step : 7 | Pilot Run (Optional) |
| | If required we can make pilot run for market analysis. |
| Step : 8 | After Sales Support (As per agreement) |
| | Any type of support we can give (As agreement for short time or life time) |
No comments:
Post a Comment